Gefen Ships Six New AV-Over-IP Products

Gefen is now shipping six new models from their Gen 2.0 AV-over-IP product line including the DVI KVM, VGA KVM and audio-only input and output formats. The Gen 2.0 KVM line claims 4K Ultra HD with HDR support, built-in scalers, video-wall control, independent USB, RS232, IR, audio routing and backward-compatibility with first-generation products.

The new Gefen AV-over-IP line-up includes a new KM Emulation feature which facilitates real-time, simultaneous keyboard and mouse control of each source from all connected workstations, eliminating the inherent limitations of earlier systems. HDMI and DisplayPort products feature maximum input resolution of 4K 60 Hz 4:2:0, and maximum output resolution of 4K 30 Hz 4:4:4. HDCP 2.2 and 1.4 are also supported. The DVI and VGA models support VESA and CEA resolutions up to WUXGA (1920×1200 at 60 Hz) and 1080p Full HD (1920×1080 at 60 Hz).

The Sender units (except DisplayPort) feature a video output for local monitoring of the source. USB, RS232 two-way IR and audio can be routed independently between any sender and receiver unit, allowing end users to control any of the sources and the displays within their network.

The new digital and analog audio over IP units allow integrators to add audio-only nodes to an installation. Each receiver can play back audio from any of the Gefen AV-over-IP sender units, including audio de-embedded from HDMI inputs. These senders and receivers can be used for multi-room music, conferencing, public announcement and live venue audio projects.

All KVM and AV Receivers feature a built-in scaler as well as a video wall controller that accommodates any screen configuration up to 16×16 in sizing and manipulating live and signage content. Digital and analog audio break-out on HDMI, DVI and DisplayPort receivers allow audio that is embedded into the video to be sent to a separate audio system, enhancing the impact of presentations in large venues. HDMI models pass 7.1 channels of HBR (High Bit Rate) and LPCM digital audio from source to display.

The Receivers’ integrated USB hub with two USB 2.0 and two USB 1.1 ports accommodate touch panels, keyboard and mouse, and a variety of supported devices.

A built in two-port Gigabit switch on each receiver allows the daisy-chaining of additional receivers or other IP-enabled devices. In applications such as digital signage, where content is often replicated on multiple displays throughout the installation, the ability to cascade the receivers removes the requirement for each cable to be run directly to the main network switch.

You can see the entire line here.